Gas tank water heaters
Gas water heater repair in Waxahachie, TX
No hot water, a pilot that keeps going out, a flame that looks wrong? Gas heaters fail in a handful of ways, and gas makes safety the first thing to sort out. Read the box below, then call and describe what yours is doing.
Speak with a water heater specialist.

If you smell gas, stop here
Leave the house with everyone in it. Do not turn lights or switches on or off, do not use a lighter, and do not try to relight the pilot. From outside, call Atmos Energy or 911. Once you are safe, call us.
What is going wrong?
Common gas water heater problems and what is behind them
This is a guide to what usually causes each symptom, not a repair plan. The gas side of a heater is not a do-it-yourself job.
Safe to check, and what is not
What you can look at, and what to leave alone
Fine to look at
- Whether other gas appliances, like the stove, are working
- Whether the gas shut-off handle is in line with the pipe (open) or across it (closed)
- Whether the temperature dial on the gas control is on a heating setting, not off or vacation
- Whether the pilot flame is visible through the small window at the base
- Whether there is water around the heater
Leave to a plumber
- Anything that smells like gas
- Gas connections, the flexible gas line and the shut-off valve
- The burner, pilot assembly and thermocouple
- The gas control valve
- The flue, draft hood and vent pipe
- The temperature and pressure relief valve

The parts that wear out
What fails on a gas water heater
- Thermocouple or flame sensor. It tells the gas valve the flame is lit. When it wears out, the valve shuts the gas off and the pilot will not stay on.
- Gas control valve. It holds the temperature dial and feeds gas to the burner. When it fails, the heater may not light or may not shut off properly.
- Burner and pilot assembly. Dust and rust can clog the burner, which gives a weak or yellow flame.
- Vent and draft. Exhaust has to leave the house through the flue. A blocked or backdrafting vent is a safety problem, not just a performance one.
- The tank itself. Sediment makes the burner work harder, and an old tank can corrode through.


When you call
What happens on the call
You tell us what the heater is doing: whether it has no hot water or too little, whether the pilot stays lit, and whether you smell anything. We ask about the age and brand if you know them, and where the heater sits. From that we can say what is likely wrong and what the next step is. We do not quote times or prices on this page, so ask about both on the call.
Repair or replace
Fix the part, or change the heater
A worn thermocouple, a bad gas control valve or a dirty burner can usually be repaired. Water around the tank? See water heater leaking. A tank that has corroded through cannot. If a heater is old and keeps needing work, replacement may make more sense. See water heater repair for repairs in general or replacement and installation if the tank is done. Heater still working? See water heater maintenance and flushing. Have an electric heater instead? See electric water heater repair. Have a gas tankless unit? See tankless water heater repair. Thinking about going tankless? See tankless installation. Not sure why there is no hot water at all? Gas vs electric causes of no hot water lays it out.
Service area
Gas water heater repair in Waxahachie and nearby
- Waxahachie
- Midlothian
- Red Oak
- Ennis
- Maypearl
- Ovilla
Gas water heater repair: common questions
What is the most common problem with gas water heaters?
No hot water because the pilot light went out is the one people see most. Behind it is often a worn thermocouple or flame sensor. Sediment in the tank and a dirty burner are the other usual ones.
Can a gas hot water heater be fixed?
Often, yes. Parts like the thermocouple, the gas control valve and the burner can be repaired or replaced. A tank that is leaking from the body has corroded through and cannot be fixed.
Do plumbers work on gas water heaters?
Yes. A gas water heater is plumbing: the water lines, the gas connection and the venting. Call us and describe what it is doing.
What should I do if my gas hot water heater isn’t working?
If there is any gas smell, leave and call Atmos Energy or 911. If not, check that the gas shut-off is open, the dial is on a heating setting and other gas appliances work. If it still does not heat, call.
Is there a reset button on a gas water heater?
Many gas heaters do not have one. Most have a pilot button and a temperature dial on the gas control, and some have an igniter button. What yours has depends on the model, so check the label or call and describe it.
Is a gas leak at the water heater an emergency?
Yes. Leave first, call the gas company or 911 from outside, then call us. See emergency water heater repair.
Gas water heater not working?
Gas smell means leave first. Otherwise call and tell us what it is doing. Waxahachie, TX and nearby towns.
Tap to call(972) 472-8849