
Gas water heater replacement
A gas heater needs a gas line with a shut-off, a connector to the control valve, a vent that carries exhaust out, and enough air for the burner. Those connections are checked as part of the swap.
Old tank leaking? Heater won’t heat? Need a new one in?
We replace tank water heaters, gas and electric: the old unit comes out, the new one is set and connected, and everything is checked before we leave. Call and tell us what you have now. Water heater installation for a new spot or a new build is the same call.
Speak with a water heater specialist.

What a replacement covers
A replacement is more than setting a new tank where the old one was. The connections around the tank are what make it safe and last.
The gas or power is shut off, the water supply is closed, and the old tank is drained and disconnected.
The new tank goes in place. The hot and cold water lines, the shut-off valve, the temperature and pressure relief valve with its discharge pipe, and the gas, vent or electrical connection all get connected or checked.
The tank is filled, the connections are checked for leaks, and the heater is started and confirmed to be heating.
Worn shut-off valves and old connectors may need to be replaced too, so a new heater is not hooked up to tired parts. We’ll talk it through when you call.

Gas or electric
Most swaps stay with the same fuel, because the gas line or the circuit is already there. Moving from one to the other is a bigger job, so say so when you call.

A gas heater needs a gas line with a shut-off, a connector to the control valve, a vent that carries exhaust out, and enough air for the burner. Those connections are checked as part of the swap.

An electric heater runs on its own circuit, often with a disconnect nearby. The supply and wiring to the unit need to suit the new heater. Power stays off until the tank is full.
Before you call
A few details make the call quick. None of it needs tools.

Repair or replace?
A failed part can be fixed. A failed tank can’t. These signs usually point toward replacing. If you only have a bad part, water heater repair may be all you need.
Looking at a tankless unit? That is a different job. See tankless water heater installation or tankless water heater repair. Burst or flooding right now? See emergency water heater repair.
Looking at a heat pump (hybrid) electric unit? See heat pump water heater installation.
Call to confirm your addressQuestions
The old heater is shut off, drained and disconnected. The new one is set, and the water lines, relief valve and discharge pipe, and the gas, vent or electrical connection are made or checked. Then the tank is filled, checked for leaks and confirmed to be heating.
It is one of the jobs where mistakes cost the most. A gas heater needs a leak-free gas connection and a vent that carries exhaust out. An electric one runs on a high-voltage circuit. The relief valve, the water connections and draining the old tank all have to be right, or you risk a flood, scalding water, or a gas or carbon monoxide problem. Most homeowners are better off calling a plumber.
We can’t tell you from this page what your address requires. Ask the City of Waxahachie building department, or call us and we’ll talk it through.
If a part failed, repair can be enough. If the tank itself is leaking, replacing is the usual answer. Call and describe what you see, and we’ll tell you which way it points.
It can be done, but it is a bigger job than a straight swap, because the gas line, vent or electrical circuit has to change. Mention it when you call.
Call now to talk through a replacement or installation in Waxahachie, TX and nearby towns.
Tap to call(972) 472-8849